Kia Cadenza: Windshield Wiper/Washer / Windshield Wiper-Washer Switch Repair procedures

Kia Cadenza YG 2016-2025 Service Manual / Body Electrical System / Windshield Wiper/Washer / Windshield Wiper-Washer Switch Repair procedures

Inspection

Check for continuity between the terminals while operating the wiper and washer switch. If it is not normal condition, replace wiper and wiper switch.

Wiper Switch

Washer Switch

Removal

1.	Remove the steering column upper and lower shrouds after removing 3 screws.

2.	Remove the wiper switch connector (A) by releasing the part.

3.	If necessary of removing the wiper & washer switch (A) only, release the lock of wiper switch using tool without removing the steering wheel and the clock spring.

Installation

1.	Install the wiper switch.

2.	Install the steering column upper and lower shrouds.

Components and Components Location

Component Location 1. Windshield wiper arm & blade2. Wiper & washer switch3. Windshield washer hose4. Windshield wiper motor & linkage5. Washer motor6. Washer reservoir7. Wiper relay ...

Front Wiper Motor Components and Components Location

Component Location 1. Cap2. Nut3. Wiper arm & blade4. Rivet5. Cowl top cover6. Bolt7. Wiper motor & linkage assembly ...

Other information:

Kia Cadenza YG 2016-2025 Service Manual: Blower Unit Components and Components Location

Component Location Components 1. Duct Seal2. Duct Case3. Inlet Door4. Intake Actuator5. Inlet Duct Case (A)6. Climate control air filter7. Cluster Ionizer8. Climate control air filter Cover9. Blower Upper Case10. Blower Lower Case11. FET12. Resistor13. Blower Motor ...

Kia Cadenza YG 2016-2025 Service Manual: Side Impact Sensor (SIS) Description and Operation

Description Side Impact Sensor (SIS) system consists of two P-SIS which are installed at each center of the front door module (LH and RH) and two SIS which are installed at each rear pillar nearby (LH and RH). Side Pressure Sensor is also called P-SIS because it detects pressure due to colli ...