Kia Cadenza: Fuel Delivery System / Accelerator Pedal Repair procedures

Kia Cadenza YG 2016-2025 Service Manual / Engine Control / Fuel System / Fuel Delivery System / Accelerator Pedal Repair procedures

Removal

1.	Turn the ignition switch OFF and disconnect the negative (-) battery cable.

2.	Disconnect the accelerator position sensor connector (A).

3.	Remove the installation nuts (B) and bolt (C), and then remove the accelerator pedal module.

Installation

Install in the reverse order of removal.

Accelerator pedal module installation nut:

12.7 ~ 15.7 N.m (1.3 ~ 1.6 kgf.m, 9.4 ~ 11.6 lb-ft)

Accelerator pedal module installation bolt:

8.8 ~ 13.7 N.m (0.9 ~ 1.4 kgf.m, 6.5 ~ 10.1 lb-ft)

Filler-Neck Assembly Repair procedures

Removal 1. Open the fuel filler door and then remove the filler-neck installation screw (A). 2. Lift the vehicle. 3. Remove the rear-LH wheel, tire, and the inner wheel house. 4. Disco ...

Delivery Pipe Repair procedures

Removal In case of removing the high pressure fuel pump, high pressure fuel pipe, delivery pipe, and injector, there may be injury caused by leakage of the high pre ...

Other information:

Kia Cadenza YG 2016-2025 Service Manual: Power Window Motor Repair procedures

Inspection Front Power Window Motor Inspection 1. Remove the front door trim panel. (Refer to Body - "Front Door") 2. Disconnect the connector from the motor. 3. Connect the terminal No. 1 and No. 2 to battery voltage (12V) and terminal No. 6 to battery (-). And then check that the m ...

Kia Cadenza YG 2016-2025 Service Manual: Brake Pedal Repair procedures

Removal 1. Remove the crash pad lower panel. (Refer to the Body group- crash pad). 2. Remove the shower duct (A). 3. Disconnect the stop lamp switch connector (A). 4. Remove the brake pedal member mounting nut (B). Tightening torque: 9.8 ~ 14.7 N.m (1.0 ~ 1.5 kgf.m, 7.2 ~ 10.8lb- ...