Kia Cadenza: Fuel Delivery System / Filler-Neck Assembly Repair procedures

Kia Cadenza YG 2016-2025 Service Manual / Engine Control / Fuel System / Fuel Delivery System / Filler-Neck Assembly Repair procedures

Removal

1.	Open the fuel filler door and then remove the filler-neck installation screw (A).

2.	Lift the vehicle.

3.	Remove the rear-LH wheel, tire, and the inner wheel house.

4.	Disconnect the fuel filler hose (A).

5.	Disconnect the ventilation hose (B) from the fuel tank air filter.

6.	Remove the filler-neck assembly from the vehicle after removing the bracket installation bolt (A).

Installation

Install in the reverse order of removal.

Filler-neck assembly bracket installation bolt :

7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

Filler-neck assembly installation screw :

7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

Fuel Line Repair procedures

Removal In case of removing the high pressure fuel pump, high pressure fuel pipe, delivery pipe, and injector, there may be injury caused by leakage of the high pre ...

Accelerator Pedal Repair procedures

Removal 1. Turn the ignition switch OFF and disconnect the negative (-) battery cable. 2. Disconnect the accelerator position sensor connector (A). 3. Remove the installation nuts (B) and ...

Other information:

Kia Cadenza YG 2016-2025 Service Manual: Idler Components and Components Location

Components 1. Idler ...

Kia Cadenza YG 2016-2025 Service Manual: Underdrive Brake Control Solenoid Valve(UD/B_VFS) Repair procedures

Inspection 1. Turn ignition switch OFF. 2. Remove the battery and battery tray. (Refer to Engine Electrical System - "Battery") 3. Disconnect the solenoid valve connector (A). 4. Measure the resistance between power terminal (5) and signal terminal (16). Specification : 5.1 ± ...