Kia Cadenza: Warning message and control / Detecting Sensor (front view camera/ rear corner radars)

Kia Cadenza YG 2016-2025 Owners Manual / Driving your vehicle / Blind-Spot Collision Warning (BCW)/ Blind-Spot Collision-Avoidance Assist (BCA) / Warning message and control / Detecting Sensor (front view camera/ rear corner radars)

Front view camera

The front view camera is a sensor detecting the lane. If the front view camera is covered by heavy rain, heavy snow and fog or foreign objects, dust, the system may temporarily be cancelled and not work properly until the cancellation due to the degradation of the sensor's detection performance. Always keep the sensor clean.

* Refer “Lane Keeping Assist (LKA)” for cautions for the front view camera.

Rear corner radars

The rear corner radars are the sensors inside the rear bumper for detecting the side/rear areas. Always keep the rear bumper clean for proper operation of the system.

CAUTION

Blind-Spot Collision-Avoidance Assist
Blind-Spot Collision-Avoidance Assist may apply braking power, when an approaching vehicle is detected within a certain distance next to/behind your vehicle. It gently applies braking pow ...

Warning message
Blind-Spot Collision Warning (BCW) system disabled. Radar blocked • This warning message may appear when : - One or both of the sensors on the rear bumper is blocked by dirt or snow or ...

Other information:

Kia Cadenza YG 2016-2025 Service Manual: Relay Box (Passenger Compartment) Repair procedures


Fuse Inspection 1. Be sure there is no play in the fuse holders, and that the fuses are held securely. 2. Are the fuse capacities for each circuit correct? 3. Are there any blown fuses? If a fuse is to be replaced, be sure to use a new fuse of the same capacity. Always determine why t ...

Kia Cadenza YG 2016-2025 Service Manual: Head Lamps Repair procedures


Inspection 1. Check-points upon head lamp failure (HID) (1) Check the battery voltage. (Low beam will be on when the battery voltage above 9V.) (2) Check the fuse and relay. (3) Check the polarity of ballast. (If the polarity are changed, low beam doesn''t lighten) (4) Check the bu ...

Copyright © www.kcadenzavg.com 2017-2025