| Removal and Installation |
| 1. |
Remove the engine cover (A).
|
| 2. |
Installation is reverse order of removal |
Components 1. Engine room front under cover2. Engine room RH side cover3. Engine room LH side cover
Removal Height Sensor 1. Disconnect the negative (-) battery terminal. 2. Remove the height sensor linkage (A) installed on the front axle and rear axle. [Front] [Rear] Installation Height Sensor 1. Install the height sensor assembly after connecting the connector.
Inspection Tolerance Calibration Tolerance calibration compensates for the error margins of surround view video that occur due to the installation tolerance when the four cameras that comprise the SVM system are installed. You must carry out tolerance calibration if you do any of the following.