Kia Cadenza YG: SRSCM / Front Impact Sensor (FIS) Description and Operation

Kia Cadenza YG 2016-2021 Service Manual / Restraint / SRSCM / Front Impact Sensor (FIS) Description and Operation

Description
The front impact sensor (FIS) is installed in the Front End Module (FEM). They are remote sensors that detect acceleration due to a collision at its mounting location. The primary purpose of the Front Impact Sensor (FIS) is to provide an indication of a collision. The Front Impact Sensor (FIS) sends acceleration data to the SRSCM.

    Removal 1. Remove the ignition key from the vehicle. 2. Disconnect the battery negative cable and wait for at least three minutes before beginning work.

    Components

    Other information:

    Kia Cadenza YG 2016-2021 Service Manual: Height Sensor Repair procedures

    Removal Height Sensor 1. Disconnect the negative (-) battery terminal. 2. Remove the height sensor linkage (A) installed on the front axle and rear axle. [Front] [Rear] Installation Height Sensor 1. Install the height sensor assembly after connecting the connector.

    Kia Cadenza YG 2016-2021 Service Manual: Blind Spot Detection Switch Repair procedures

    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the passenger compartment junction box cover. 3. Remove the driver side cover (A). 4. Remove the crash pad side switch assembly (A) by pushing it through side cover hole.

    Categories

     
    Copyright © 2026 www.kcadenzavg.com - 0.0341