Kia Cadenza YG: Exhaust Emission Control System / Catalytic Converter Repair procedures
| Removal |
| [Catalytic Converter (WCC)] |
| 1. |
Remove the exhaust manifold.
(Refer to Engine Mechanical System - "Exhaust Manifold")
|
| [Catalytic Converter (UCC)] |
| 1. |
Remove the Center Muffler.
(Refer to Engine Mechanical System - "Center Muffler")
|
| Installation |
| 1. |
Install in the reverse order of removal. |
Description The catalytic converter of the gasoline engine is a three way catalyst. It oxidizes carbon monoxide and hydrocarbons (HC), and separates oxygen from the oxides of nitrogen (NOx).
Description Continuous Variable Valve Timing (CVVT) system advances or retards the valve timing of the intake and exhaust valve in accordance with the ECM control signal which is calculated by the engine speed and load.
Other information:
Kia Cadenza YG 2016-2021 Service Manual: Description and Operation
Description BSD is a system that uses two magnetic wave radar sensors attached on the rear bumper to measure the distance from the following vehicles and provides the sensing and (visual and auditory) alarm of any vehicle coming into the blind spot.
Kia Cadenza YG 2016-2021 Service Manual: Power Mosfet Repair procedures
Inspection 1. Ignition "ON" 2. Manually operate the control switch and measure the voltage of blower motor. 3. Select the control switch to raise voltage until high speed. Specification FanMotor VoltageManualFirst speed3.8 ±0.5VSecond speed5.
Categories
- Manuals Home
- Kia Cadenza Owners Manual
- Kia Cadenza Service Manual
- General Information
- Driveshaft and axle
- Schematic Diagrams
- New on site
- Most important about car
