Kia Cadenza YG: Airbag Module / Driver Airbag (DAB) Module and Clock Spring Description and Operation
Kia Cadenza YG 2016-2021 Service Manual / Restraint / Airbag Module / Driver Airbag (DAB) Module and Clock Spring Description and Operation
| Description |
Driver Airbag (DAB) is installed in the steering wheel and
electrically connected to SRSCM via the clock spring. It protects the
driver by deploying the airbag when frontal crash occurs. The SRSCM
determines deployment of the Driver Airbag (DAB).
Never attempt to measure the circuit resistance of the airbag
module (squib) even if you are using the specified tester. If the
circuit resistance is measured with a tester, accidental airbag
deployment will result in serious personal injury. |
Components 1. Driver Airbag (DAB)2. Steering Wheel3. Clock Spring
Other information:
Kia Cadenza YG 2016-2021 Service Manual: Lane Departure Warning System (LDWS) Unit Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the LDWS unit cover (A). 3. Remove the LDWS unit connector (A). 4. Remove the LDWS unit after widening the mounting clips. Installation 1. Install the LDWS unit. 2.
Kia Cadenza YG 2016-2021 Service Manual: Evaporator unit Repair procedures
Inspection 1. Ignition "OFF". 2. Disconnect evaporator temperature sensor. 3. Using the multi-tester, Measure resistance between terminal "1" and "2" of evaporator temperature sensor. Specification Evaporator coretemperature [°C(°F)]Resistance[KΩ]Voltage[V]-20(-4)70.
Categories
- Manuals Home
- Kia Cadenza Owners Manual
- Kia Cadenza Service Manual
- Suspension System
- Front Bumper Repair procedures
- General Information
- New on site
- Most important about car
Copyright © 2025 www.kcadenzavg.com - 0.0198