Kia Cadenza YG: Engine And Transmission Assembly / Engine Cover Repair procedures

Kia Cadenza YG 2016-2021 Service Manual / Engine Mechanical System / Engine And Transmission Assembly / Engine Cover Repair procedures

Removal and Installation
1.
Remove the engine cover (A).

   
•
Lift up the lower end of engine cover, then left and right alternately.
•
When installing, confirm that the mounting rubber insulators has been installed.
2.
Installation is reverse order of removal

    Components 1. Engine room front under cover2. Engine room RH side cover3. Engine room LH side cover

    Other information:

    Kia Cadenza YG 2016-2021 Service Manual: A/C Pressure Transducer Description and Operation

    Description A/C pressure transducer convert the pressure value of high pressure line into voltage value after measure it. By converted voltage value, engine ECU controls cooling fan by operating it high speed or low speed. Engine ECU stop the operation of compressor when the temperature of refrigerant line is so high or so low irregularl

    Kia Cadenza YG 2016-2021 Service Manual: Mode Control Actuator Repair procedures

    Inspection 1. Ignition "OFF” 2. Disconnect the connector of mode control actuator. 3. Verify that the mode control actuator operates to the defrost mode when connecting 12V to the terminal 3and grounding terminal 7. 4. Verify that the mode control actuator operates to the vent mode when connecting in the reverse.

    Categories

     
    Copyright © 2026 www.kcadenzavg.com - 0.0197