Kia Cadenza YG: Fuel Delivery System / Fuel Shut Off Valve Repair procedures

Kia Cadenza YG 2016-2021 Service Manual / Engine Control / Fuel System / Fuel Delivery System / Fuel Shut Off Valve Repair procedures

Removal
1.
Lift the vehicle and support the fuel tank with a jack.
2.
Remove the nuts from fuel tank.
3.
Release the fuel tank bands (A).

4.
Disconnect the fuel filler hose (A).

5.
Remove the fuel shut off valve (A).

Installation
1.
Install in the reverse order of removal.
Inspection
1.
Visually check if the valve is are deformed or damaged.
2.
Check if the valve spring is oprerated normally.

    Removal     In case of removing the high pressure fuel pump, high pressure fuel pipe, delivery pipe, and injector, there may be injury caused by leakage of the high pressure fuel.

    Other information:

    Kia Cadenza YG 2016-2021 Service Manual: Start/Stop Button Repair procedures

    Removal 1. Disconnect the negative (-) battery terminal. 2. Using a screw driver or remover, remove the center fascia lower panel (A). 3. Remove the in-car hose (A) and disconnect the connectors (B) from the heater & A/C control unit. 4.

    Kia Cadenza YG 2016-2021 Service Manual: Blower Resistor Repair procedures

    Inspection 1. Measure terminal - to - terminal resistance of blower resistor. 2. If measure resistance isnot within specification, the blower resistor must be replaced. Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower cover (A) and then disconnect the connector (B).

    Categories

     
    Copyright © 2026 www.kcadenzavg.com - 0.0184