Kia Cadenza YG: Automatic Transaxle Control System / Inhibitor Switch Description and Operation

Kia Cadenza YG 2016-2021 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Inhibitor Switch Description and Operation

Description
Inhibitor Switch monitors the lever''s position(P, R, N, D) and is used to control gear setting signals.

    Inspection 1. Turn ignition switch OFF. 2. Remove the battery and battery tray. (Refer to Engine Electrical System - "Battery") 3. Disconnect the solenoid valve connector (A).

    Specifications ▷ Type: Combination of output signals from 4 terminals ▷ Specifications Power supply (V)12Output typePin to Pin ▷ Signal Code Table 　PP-RRR-NNN-DDS112V12V00000S2012V12V12V000S300012V12V12V0S40000012V12V

    Other information:

    Kia Cadenza YG 2016-2021 Service Manual: Repair procedures

    Teaching Procedures 1. Key Teaching Procedure Key teaching must be done after replacing a defective PCM(ECM) or when providing additional keys to the vehicle owner. The procedure starts with an PCM(ECM) request for vehicle specific data (PIN code: 6digits) from the tester.

    Kia Cadenza YG 2016-2021 Service Manual: Refrigerant line Repair procedures

    Replacement 1. Discharge refrigerant from refrigeration system. 2. Replace faulty tube or hose.     Cap the open fittings immediately to keep moisture or dirt out of the system. 3. Tighten joint of bolt or nut to specified torque.

    Categories

     
    Copyright © 2026 www.kcadenzavg.com - 0.0333