| Circuit Diagram |




Components Connector Pin Information No.DescriptionNo.Description1Air bag (+)21Aig bag (-)2Trip switch (+)22Speaker output (+)3Cruise switch (+)23Speaker output (-)4Rheostat down switch (-)24Trip switch (-)5Rheostat up switch (-)25VS 4P output (-)6Oil pressure (-)26AT R output (+)7Washer indicator (-)27AT P output (+)8Battery charge (-)28Detent output (+)9H/SWHL indicator (+)29Immobilizer (-)10Brake oil switch (-)30MM CAN high11Active ECO switch (-)31MM CAN low12Driving mode switch (-)32C CAN low13AT D output (+)33C CAN high14Fuel (+)34AT N output (+)15AT S output (+)(AT)35Illumniation (-)16Fuel (-)36P ground17-37S ground18Glass status signal (-)38-19-39IGN 1 (+)20Illumination (+)40Battery (+)
Inspection Speedometer 1. Adjust the pressure of the tires to the specified level. 2. Drive the vehicle onto a speedometer tester. Use wheel chocks (A) as appropriate.
System Overview RPAS (Rear Parking Assist System) is an electronic driving aid that warns the driver to be cautious while parking or in low speed environments. The sensor uses ultrasonic waves to detect objects within proximity of the vehicle.
Replacement 1. Disconnect the negative (-) battery terminal. 2. Recover the refrigerant with a recovery/ recycling/ charging station. 3. When the engine is cool, drain the engine coolant from the radiator. 4. Remove the expansion valve cover (A).