Kia Cadenza YG: Lubrication System / Oil Pressure Switch Components and Components Location
| Components |
| 1. Oil cover 2. Oil cover gasket | 3. Oil pressure switch |
Removal and Installation 1. Remove the lower oil pan. (Refer to Lubrication System - "Oil Pan") 2. Remove the oil pump chain cover (A). Tightening torque : 9.
Removal and Installaion 1. Remove the intake manifold. (Refer to Intake And Exhaust System - "Intake Manifold") 2. Remove the delivery pipe and injector.
Other information:
Kia Cadenza YG 2016-2021 Service Manual: Refrigerant line Repair procedures
Replacement 1. Discharge refrigerant from refrigeration system. 2. Replace faulty tube or hose. Cap the open fittings immediately to keep moisture or dirt out of the system. 3. Tighten joint of bolt or nut to specified torque.
Kia Cadenza YG 2016-2021 Service Manual: Compressor Repair procedures
Removal 1. If the compressor is marginally operable, run the engine at idle speed, and let the air conditioning work for a few minutes, then shut the engine off. 2. Disconnect the negative cable from the battery. 3. Recover the refrigerant with a recovery/charging station.
Categories
- Manuals Home
- Kia Cadenza Owners Manual
- Kia Cadenza Service Manual
- Rail Pressure Sensor (RPS) Schematic Diagrams
- Schematic Diagrams
- General Information
- New on site
- Most important about car
