Kia Cadenza YG: Lubrication System / Oil Pump Repair procedures

Kia Cadenza YG 2016-2021 Service Manual / Engine Mechanical System / Lubrication System / Oil Pump Repair procedures

Removal and Installation
1.
Remove the lower oil pan.
(Refer to Lubrication System - "Oil Pan")
2.
Remove the oil pump chain cover (A).
Tightening torque :
9.8 ~ 11.8N.m (1.0 ~ 1.2kgf.m, 7.2 ~ 8.7lb-ft)

3.
Remove the bolt (A) and then seperate the chain with sprocket from the oil pump.
Tightening torque :
18.6 ~ 21.6N.m (1.9 ~ 2.2kgf.m, 13.7 ~ 15.9lb-ft)

4.
Remove the oil pump (A).
Tightening torque :
20.6 ~ 22.6N.m (2.1 ~ 2.3kgf.m, 15.2 ~ 16.6lb-ft)

   
When installing, use a new O-ring.
5.
Install in the reverse order of removal.
6.
After assembly, wait at least 30 minutes before filling the engine with oil.

    Components 1. Oil pump2. O-ring3. Oil pump sprocket4. Oil pump chain cover

    Components 1. Oil cover2. Oil cover gasket3. Oil pressure switch

    Other information:

    Kia Cadenza YG 2016-2021 Service Manual: Refrigerant line Repair procedures

    Replacement 1. Discharge refrigerant from refrigeration system. 2. Replace faulty tube or hose.     Cap the open fittings immediately to keep moisture or dirt out of the system. 3. Tighten joint of bolt or nut to specified torque.

    Kia Cadenza YG 2016-2021 Service Manual: Power Mosfet Repair procedures

    Inspection 1. Ignition "ON" 2. Manually operate the control switch and measure the voltage of blower motor. 3. Select the control switch to raise voltage until high speed. Specification FanMotor VoltageManualFirst speed3.8 ±0.5VSecond speed5.

    Categories

     
    Copyright © 2026 www.kcadenzavg.com - 0.0237