Kia Cadenza YG: Panoramaroof / Panoramaroof Switch Repair procedures
| Inspection |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the overhead console lamp assembly.
(Refer to Body - "Roof Trim") |
| 3. |
Check for continuity between the terminals. If the continuity is not as specified, replace the panoramaroof switch.
|
Circuit Diagram (1) Circuit Diagram (2)
Inspection 1. Disconnect the negative (-) battery terminal. 2. Remove the roof trim. (Refer to Body - "Roof Trim") 3. Disconnect the panoramaroof motor (A) connector.
Other information:
Kia Cadenza YG 2016-2021 Service Manual: Adaptive Front Lighting System Description and Operation
Description AFLS Unit(ECU) AFLS located in Cockpit Module is provided information of vehicle (steering wheel signal,vehicle speed, inclination of vehicle). Based on provided information , it calculates algorithm and adjust Low beam of H/Lamp. It transmits driving information by using LIN protocol, it is operated in Fail-safe reaction mode
Kia Cadenza YG 2016-2021 Service Manual: Blind Spot Detection Unit Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the rear bumper. (Refer to Body - "Rear Bumper") 3. Remove the BSD unit (A) after loosening the mounting screws. Take care not to separate the bracket from rear bumper when removing the BSD sensor.
Categories
- Manuals Home
- Kia Cadenza Owners Manual
- Kia Cadenza Service Manual
- Mode Control Actuator Repair procedures
- Driveshaft and axle
- Schematic Diagrams
- New on site
- Most important about car
