Kia Cadenza YG: Steering wheel / Repair procedures

Kia Cadenza YG 2016-2021 Service Manual / Steering System / Steering wheel / Repair procedures

Removal
1.
Disconnect the battery negative cable from the battery and then wait for at least 30 seconds.
2.
Turn the steering wheel so that the front wheels can face straight ahead.
3.
Remove the airbag module.
(Refer to Restraint - “Driver Airbag (DAB) Module”)
4.
Disconnect the lock nut (A) & connector (B) and then remove the steering wheel by using special service tools. (09561-11001)
Tightening torque : (~2012.09.23)
39.2~44.1N.m (4.0~4.5Kgf.m, 28.9~32.5lb-ft)
Tightening torque : (2012.09.24~)
39.2~49.1N.m (4.0~4.5Kgf.m, 28.9~36.2lb-ft)

   
•
Do not hammer on the steering wheel to remove it; it may damage the steering column.
5.
Installation is the reverse of the removal.
Disaseembly
1.
Loosen the screw (6ea) and remove the lower cover (A) from the steering wheel body.

2.
Disconnect the Wiring (A).

3.
Loosen the screw (2ea) and remove the remote control assembly (A) from the steering wheel body.

4.
Installation is the reverse of the removal.

    Component 1. Driver airbag (DAB) 2. Remote control switch 3. Steering wheel body 4. Wiring 5. Paddle shifter switch 6. Lower cover 7.

    Description When manually selected, the heated steering wheel system improves the thermal comfort of the driver by heating the steering wheel. Heated control unit Heated pad Specifications ItemSpecificationVoltage13.

    Other information:

    Kia Cadenza YG 2016-2021 Service Manual: Repair procedures

    Removal 1. Remove the trunk trim in the trunk after removing the screws and clips. (Refer to Body - "Trunk") 2. Remove the camera holder (A) as shown arrow direction, and then remove the back view camera (B). Installation 1. Install the back view camera and camera holder.

    Kia Cadenza YG 2016-2021 Service Manual: Evaporator unit Repair procedures

    Inspection 1. Ignition "OFF". 2. Disconnect evaporator temperature sensor. 3. Using the multi-tester, Measure resistance between terminal "1" and "2" of evaporator temperature sensor. Specification Evaporator coretemperature [°C(°F)]Resistance[KΩ]Voltage[V]-20(-4)70.

    Categories

     
    Copyright © 2026 www.kcadenzavg.com - 0.0295