Kia Cadenza YG: Automatic Transaxle System / Special Service Tools

Kia Cadenza YG 2016-2021 Service Manual / Automatic Transaxle System / Special Service Tools

Special Service Tools
Tool Name / Number
Illustration
Description
Engine support fixture
(Beam)
09200-3N000

Used for holding engine assembly when removing / installing transaxle.
Used with the supporter (09200-2S200) and adapter (09200-1P100).
Engine support fixture
(Supporter)
09200-2S200

Used for holding engine assembly when removing / installing transaxle.
Used with the beam (09200-3N000) and adapter (09200-1P100).
Engine support fixture
(Adaptor)
09200-1P100

Used for holding engine assembly when removing / installing transaxle.
Used with the beam (09200-3N000) and supporter (09200-2S200).
Oil seal installer
09453-3L240

Installation of transaxle oil seal.
Used with the handle (09231-H1100).
handle
09231-H1100

Installation of transaxle oil seal.
Used with the oil seal installer (09453-3L240).
Inhibitor switch guide pin
09480-A3800

Used for fixing "N" range when installing inhibitor switch

※ Engine support fixture assembly drawing

    Specifications ItemSpecificationsTransaxle  typeA6LF2Engine modelGasoline  3.3 GDITorque converter type3-element, 1-stage, 2-phase typeTorque converter sizeΦ260mm(10.

    Troubleshooting Limp Home Mode Features a fail-safe function that prevents dangerous situations in the event of a transaxle failure. The vehicle will be driven in limp home mode if the transaxle malfunctions.

    Other information:

    Kia Cadenza YG 2016-2021 Service Manual: Surround View Monitoring Switch Repair procedures

    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the floor console upper cover. (Refer to Body - "Floor Console Assembly") 3. Disconnect the console upper cover connector (A). 4. Remove the cup holder assembly (A) after loosening the mounting screws.

    Kia Cadenza YG 2016-2021 Service Manual: Parking Assist Sensor Repair procedures

    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the rear bumper cover. (Refer to Body - "Rear Bumper Cover") 3. Disconnect the connector (A) from the parking assist sensor. 4. Pull out the sensor (A) by opening the sensor holder (B) out.

    Categories

     
    Copyright © 2026 www.kcadenzavg.com - 0.0198