| General Information |
| Specifications |
| Item | Specification | |
| Type | Motor Driven Power Steering | |
| Steering gear | Type | Rack & Pinion |
| Rack stroke | 148mm (5.8268 in.) | |
| Steering angle (Max.) | Inner | 39.9 °±1.5 ° |
| Outer | 32.8 ° | |
| Tightening Torques |
| Item | Tightening torque (kgf.m) | ||
| Nm | kgf.m | lb-ft | |
| Lub nuts | 88.3 ~ 107.9 | 9.0 ~ 11.0 | 65.1 ~ 79.6 |
| Steering wheel lock nut | 39.2 ~ 49.0 | 4.5 ~ 5.0 | 28.9 ~ 36.2 |
| Steering column mounting bolts and nuts | 12.7 ~ 17.7 | 1.3 ~ 1.8 | 9.4 ~ 13.0 |
| Universal join to pinion of steering gear | 32.4 ~ 37.3 | 3.3 ~ 3.8 | 23.9 ~ 27.5 |
| Tie rod end castle nut | 34.3 ~ 44.1 | 3.5 ~ 4.5 | 25.3 ~ 32.5 |
| Lower arm ball joint bolts | 98.1 ~ 117.7 | 10.0 ~ 12.0 | 72.3 ~ 86.8 |
| Steering gear box mounting bolts | 88.3 ~ 107.9 | 9.0 ~ 11.0 | 65.1 ~ 79.6 |
| Stabilizer link nut | 98.1 ~ 117.7 | 10.0 ~ 12.0 | 72.3 ~ 86.8 |
| Sub frame stay mounting bolts & nuts | 44.1 ~ 58.8 | 4.5 ~ 6.0 | 32.5 ~ 43.4 |
| Sub frame mounting bolts & nuts | 156.9 ~ 176.5 | 16.0 ~ 18.0 | 115.7 ~ 130.2 |
| Steering column assembly to universal joint | 49.0 ~ 58.8 | 5.0 ~ 6.0 | 36.2 ~ 43.4 |
Special Service Tools Tool Name / NumberIIIustrationDescriptionSteering whell puller09561-11001Remove the steering wheel from the column shaft.Lower arm ball joint remover0K545-A9100Removal of front lower arm from front axle
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the rear bumper. (Refer to Body - "Rear Bumper") 3. Remove the BSD unit (A) after loosening the mounting screws. Take care not to separate the bracket from rear bumper when removing the BSD sensor.
Inspection 1. Connect the battery voltage and check the blower motor rotation. 2. If the blower motor voltage is not operated well, substitute with a known-good blower motor and check for proper operation. 3. If the problem is corrected, replace the blower motor.