Kia Cadenza YG: Automatic Transaxle Control System / Underdrive Brake Control Solenoid Valve(UD/B_VFS) Specifications
| Specification |
| Item | Specification |
| Control type | N/H (Normal High) |
| "Control pressure kpa (kgf/cm², psi)" | "500.14 ~ 9.81 (5.1 ~ 0.1, 72.54 ~ 1.42)" |
| Current value (mA) | 50 ~ 850 |
| Coil resistance(Ω) | 5.1 ± 0.3 |
Inspection 1. Turn ignition switch OFF. 2. Remove the battery and battery tray. (Refer to Engine Electrical System - "Battery") 3. Disconnect the solenoid valve connector (A).
Component Location 1. Underdrive brake control solenoid valve (UD/B_VFS)
Other information:
Kia Cadenza YG 2016-2021 Service Manual: Evaporator unit Repair procedures
Inspection 1. Ignition "OFF". 2. Disconnect evaporator temperature sensor. 3. Using the multi-tester, Measure resistance between terminal "1" and "2" of evaporator temperature sensor. Specification Evaporator coretemperature [°C(°F)]Resistance[KΩ]Voltage[V]-20(-4)70.
Kia Cadenza YG 2016-2021 Service Manual: Photo Sensor Repair procedures
Inspection 1. Ignition "ON" 2. Using the scan tool. 3. Emit intensive light toward photo sensor using a lamp, and check the output voltage change. 4. The voltage will rise with higher intensive light and reduce with lower intensive light.
Categories
- Manuals Home
- Kia Cadenza Owners Manual
- Kia Cadenza Service Manual
- Automatic Transaxle System
- General Information
- Alternator Schematic Diagrams
- New on site
- Most important about car
