Kia Cadenza YG: Windshield Wiper/Washer / Windshield Wiper-Washer Switch Repair procedures

Kia Cadenza YG 2016-2021 Service Manual / Body Electrical System / Windshield Wiper/Washer / Windshield Wiper-Washer Switch Repair procedures

Inspection
Check for continuity between the terminals while operating the wiper and washer switch. If it is not normal condition, replace wiper and wiper switch.

Wiper Switch

Washer Switch

Removal
1.
Remove the steering column upper and lower shrouds after removing 3 screws.

2.
Remove the wiper switch connector (A) by releasing the part.

3.
If necessary of removing the wiper & washer switch (A) only, release the lock of wiper switch using tool without removing the steering wheel and the clock spring.

Installation
1.
Install the wiper switch.
2.
Install the steering column upper and lower shrouds.

    Component Location 1. Windshield wiper arm & blade2. Wiper & washer switch3. Windshield washer hose4. Windshield wiper motor & linkage5.

    Component Location 1. Cap2. Nut3. Wiper arm & blade4. Rivet5. Cowl top cover6. Bolt7. Wiper motor & linkage assembly

    Other information:

    Kia Cadenza YG 2016-2021 Service Manual: Blind Spot Detection Unit Repair procedures

    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the rear bumper. (Refer to Body - "Rear Bumper") 3. Remove the BSD unit (A) after loosening the mounting screws.     Take care not to separate the bracket from rear bumper when removing the BSD sensor.

    Kia Cadenza YG 2016-2021 Service Manual: Power Mosfet Repair procedures

    Inspection 1. Ignition "ON" 2. Manually operate the control switch and measure the voltage of blower motor. 3. Select the control switch to raise voltage until high speed. Specification FanMotor VoltageManualFirst speed3.8 ±0.5VSecond speed5.

    Categories

     
    Copyright © 2026 www.kcadenzavg.com - 0.0293