Kia Cadenza YG: Exterior / Mirror Repair procedures

Kia Cadenza YG 2016-2021 Service Manual / Body (Interior and Exterior) / Exterior / Mirror Repair procedures

Replacement
Outside Rear View Mirror Replacement
   
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Put on gloves to protect your hands.
1.
Using a screwdriver or remover, remove the front door frame inner cover (A).

2.
Disconnect the outside rear view mirror connector (A).
3.
After loosening the mounting nuts, then remove the outside rear view mirror (B).
Tightening torque :
6.9~10.8 N.m(0.7~1.1 kgf.m, 5.1~8.0 lb-ft)

4.
Installation is the reverse of removal.
Inside Rear View Mirror Assembly Replacement
Mirror Replacement
1.
Push the inside rear view mirror base (A) down to remove the inside rear view mirror assembly (B).

2.
Installation is the reverse of removal.
ECM Mirror Replacement
1.
Remove the ECM mirror cover (A).
2.
Disconnect the ECM mirror connector (B).

3.
Loosen the ECM mirror mounting screw (A).
4.
Push the ECM mirror base up to remove the ECM mirror assembly (B).

5.
Installation is the reverse of removal.
   
•
Make sure the connector is connected properly.

    Replacements Movable glass Replacement 1. Open the movable glass fully. 2. Remove the folding cover (A). 3. After loosening the mounting screws, then remove the movable glass (A).

    Replacement 1. Remove the cover (B) and remove the nuts, then remove the wiper arm (A). Tightening torque : 22.6~26.5 N.m(2.3~2.7 kgf.m, 16.6~19.

    Other information:

    Kia Cadenza YG 2016-2021 Service Manual: Compressor Oil Repair procedures

    Oil Specification 1. The HFC-134a system requires synthetic (PAG) compressor oil whereas the R-12 system requires mineral compressor oil. The two oils must never be mixed. 2. Compressor (PAG) oil varies according to compressor model. Be sure to use oil specified for the model of compressor.

    Kia Cadenza YG 2016-2021 Service Manual: Mode Control Actuator Repair procedures

    Inspection 1. Ignition "OFF” 2. Disconnect the connector of mode control actuator. 3. Verify that the mode control actuator operates to the defrost mode when connecting 12V to the terminal 3and grounding terminal 7. 4. Verify that the mode control actuator operates to the vent mode when connecting in the reverse.

    Categories

     
    Copyright © 2026 www.kcadenzavg.com - 0.0204