Kia Cadenza YG: Heater / Mode Control Actuator Description and Operation

Kia Cadenza YG 2016-2021 Service Manual / Heating,Ventilation, Air Conditioning / Heater / Mode Control Actuator Description and Operation

Description
The mode control actuator is located at the heater unit.
It adjusts position of mode door by operating mode control actuator based on signal of A/C control unit. Pressing mode select switch makes the mode control actuator shift in order of vent→ B/L → floor → mix.

    Component Location

    Inspection 1. Ignition "OFF” 2. Disconnect the connector of mode control actuator. 3. Verify that the mode control actuator operates to the defrost mode when connecting 12V to the terminal 3and grounding terminal 7.

    Other information:

    Kia Cadenza YG 2016-2021 Service Manual: Repair procedures

    Inspection Tolerance Calibration Tolerance calibration compensates for the error margins of surround view video that occur due to the installation tolerance when the four cameras that comprise the SVM system are installed. You must carry out tolerance calibration if you do any of the following.

    Kia Cadenza YG 2016-2021 Service Manual: Power Mosfet Repair procedures

    Inspection 1. Ignition "ON" 2. Manually operate the control switch and measure the voltage of blower motor. 3. Select the control switch to raise voltage until high speed. Specification FanMotor VoltageManualFirst speed3.8 ±0.5VSecond speed5.

    Categories

     
    Copyright © 2026 www.kcadenzavg.com - 0.0261