Kia Cadenza YG: Automatic Transaxle Control System / Overdrive Clutch Control Solenoid Valve(OD/C_VFS) Description and Operation

Kia Cadenza YG 2016-2021 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Overdrive Clutch Control Solenoid Valve(OD/C_VFS) Description and Operation

Description
•
Overdrive clutch control solenoid valve is a Variable Force Solenoid (VFS) type.
•
When TCM supplies variable current to solenoid valve, hydraulic pressure of underdrive brake is controlled by solenoid valve.

Overdrive clutch control solenoid valve operation table
　
OD/C_VFS
N/H
N, P
　
1
Δ
2
●
3
●
4
　
5
　
6
　
R
　

● : Connected status
Δ : Connected at vehicle speed above 8km/h

    Component Location 1. Overdrive clutch control solenoid valve (OD/C_VFS)

    Circuit Diagram

    Other information:

    Kia Cadenza YG 2016-2021 Service Manual: Immobilizer Control Unit Repair procedures

    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad") 3. Disconnect the 5P connector of the SMARTRA unit and then remove the SMARTRA unit (A) after loosening the bolt. Installation 1.

    Kia Cadenza YG 2016-2021 Service Manual: Components and Components Location

    Component Location 1. Start Stop Button(SSB)2. FOB key3. RF receiver4. Smart key unit5. Interior antenna 16. Interior antenna 2 7. Trunk antenna8. Bumper antenna9. Door handle & door antenna10. Trunk lid open switch11.

    Categories

     
    Copyright © 2026 www.kcadenzavg.com - 0.0282