Kia Cadenza: Rear Suspension System / Rear Assist Arm Repair procedures
Kia Cadenza YG 2016-2025 Service Manual / Suspension System / Rear Suspension System / Rear Assist Arm Repair procedures
| Replacement |
| 1. |
Remove the rear wheel & tire.
|
| 2. |
Remove the sprit pin and castle nut and then disconnect the rear assist arm (A) from the rear axle.
|
| 3. |
Loosen the bolt & nut and then remove the rear assist arm (A) with the sub frame.
|
| 4. |
Installation is the reverse of removal. |
| Inspection |
| 1. |
Check the bushing for wear and deterioration. |
| 2. |
Check the rear lower arm for deformation. |
| 3. |
Check the coil spring and spring pad for deterioration and deformation. |
| 4. |
Check for all bolts and nut. |
Rear Stabilizer Bar Repair procedures
Replacement
1.
Remove the rear wheel & tire.
Tightening torque:
88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)
Be careful not to damage to the hub bolt ...
Trailing Arm Repair procedures
Replacement
1.
Remove the rear wheel & tire.
Tightening torque:
88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)
Be careful not to damage to the hub bolt ...
Other information:
Kia Cadenza YG 2016-2025 Owners Manual: Sunshade
To open the sunshade, pull the sunroof control lever backward to the first detent position. To close the sunshade when the sunroof glass is closed, push the sunroof control lever forward to the first detent position. To stop the sliding at any point, push the sunroof cont ...
Kia Cadenza YG 2016-2025 Service Manual: Engine Coolant Temperature Sensor (ECTS) Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the ECTS connector. 3. Remove the ECTS (Refer to "Removal"). 4. After immersing the thermistor of the sensor into engine coolant, measure resistance between the ECTS terminals 3 and 4. 5. Check that the resistance is withi ...
Copyright © www.kcadenzavg.com 2017-2025
