| Removal |
| 1. |
Remove the transaxle assembly.
(Refer to Automatic Transaxle System - "Automatic Transaxle") |
| 2. |
Remove the drive plate.
(Refer to Cylinder Block - "Drive Plate") |
| 3. |
Remove the rear oil seal (A).
|
| 4. |
Remove the rear oil seal case (A).
|
| Installation |
| 1. |
Install the rear oil seal case(A).
|
| 2. |
Using SST(09231-3C200, 09231-H1100), install the rear oil seal.
|
| 3. |
Install the other parts in the reverse order of removal. |
Components 1. Rear oil seal2. Oil seal case
Components 1. Piston ring2. Piston pin3. Snap ring4. Piston5. Connecting rod6. Connecting rod upper bearing7. Connecting rod lower bearing8. Connecting rod bearing cap
Replacement 1. Discharge refrigerant from refrigeration system. 2. Replace faulty tube or hose. Cap the open fittings immediately to keep moisture or dirt out of the system. 3. Tighten joint of bolt or nut to specified torque.
Inspection 1. Measure the pressure of high pressure line by measuring voltage output between NO.1 and NO.2 terminals. 2. Inspect the voltage value whether it is sufficient to be regular value or not. Voltage = 0.00878835 * Pressure + 0.37081095 [PSIA] 3.