Kia Cadenza YG: Seat Belt / Rear Seat Belt Repair procedures
Rear Seat Belt Retractor Replacement
•
When installing the belt, make sure not to damaged the retractor.
1.
Remove the following items first.
•
Rear seat assembly
(Refer to the BD group - "Rear Seat")
•
Rear Piller trim
(Refer to the BD group - "Interior Trim")
•
Package tray trim
(Refer to the BD group - "Interior Trim")
2.
After loosening the mounting bolt, then remove the rear seat belt lower anchor (A).
Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)
3.
After loosening the retractor (B) mounting bolts, then remove the rear seat belt (A).
Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)
4.
Installation is the reverse of removal.
•
Replace ant damaged clips.
Rear Center Seat Belt Retractor Replacement
•
When installing the belt, make sure not to damage the retractor.
1.
Remove the following items first :
•
Rear seat assembly
(Refer to the BD group - "Rear Seat")
•
Rear piller trim
(Refer to the BD group - "Interior Trim")
•
Package tray trim
(Refer to the BD group - "Interior Trim")
2.
After loosening the mounting bolt, then remove the rear center seat belt lower anchor (A).
Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)
3.
After loosening the mounting bolt, then remove the rear center seat belt retractor (A).
Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)
4.
Installation is the reverse of removal.
Rear Seat Belt Buckle Replacement
1.
Remove the rear seat.
(Refer to the BD group - "Rear Seat")
2.
Loosen the mounting bolt, and then remove the rear seat belt buckle (A).
Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)
[LH]
[RH]
3.
Installation is the reverse of removal.
Replacement
Front Seat Belt Replacement
•
When installing the belt, make sure not to damaged the pretensioner.
Other information: Removal
Height Sensor
1.
Remove the height sensor connector (A).
2.
Loosen the mounting bolts(Body: 2EA, chassis: 1EA) from height sensor bracket.
Tightening torque :
3 ~ 5N.m (30 ~ 50kgf.m, 2.21 ~ 3.68lb-ft)
3.
Remove the height sensor.
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad")
3.
Disconnect the 5P connector of the SMARTRA unit and then remove the SMARTRA unit (A) after loosening the bolt.
Installation
1.
