Kia Cadenza YG: Air Conditioning System / Refrigerant line Repair procedures

Replacement
1.
Discharge refrigerant from refrigeration system.
2.
Replace faulty tube or hose.
   
Cap the open fittings immediately to keep moisture or dirt out of the system.
3.
Tighten joint of bolt or nut to specified torque.
   
Connections should not be torque tighter than the specified torque.
Part tightened
N.m
Kgf.m
lbf-ft
Condenser - Discharge hose
7.8~11.7
0.8 ~ 1.2
5.7~8.6
Condenser - Liquid tube
Compressor - Discharge hose
7.8~11.7
0.8 ~ 1.2
5.7~8.6
Compressor - Suction hose
Expansion valve - Evaporator
7.8~11.7
0.8 ~ 1.2
5.7~8.6

4.
Evacuate air in refrigeration system and charge system with refrigerant.

Specified amount : 19.4 ± 0.88 oz.(550 ± 25g)

5.
Inspect for leakage of refrigerant.
Using a gas leak detector, check for leakage of refrigerant.
6.
Inspect A/C operation.

    Component Location

    Components 1. Screw2. Blot3. Limiter Assembly4. Retainer Ring5. Pulley6. Compressor Assembly

    Other information:

    Kia Cadenza YG 2016-2021 Service Manual: Mode Control Actuator Repair procedures

    Inspection 1. Ignition "OFF” 2. Disconnect the connector of mode control actuator. 3. Verify that the mode control actuator operates to the defrost mode when connecting 12V to the terminal 3and grounding terminal 7. 4. Verify that the mode control actuator operates to the vent mode when connecting in the reverse.

    Kia Cadenza YG 2016-2021 Service Manual: Blower Unit Components and Components Location

    Component Location Components 1. Duct Seal2. Duct Case3. Inlet Door4. Intake Actuator5. Inlet Duct Case (A)6. Climate control air filter7. Cluster Ionizer8. Climate control air filter Cover9. Blower Upper Case10. Blower Lower Case11. FET12. Resistor13.

    Categories

     
    Copyright © 2026 www.kcadenzavg.com - 0.0308