| Fuse Inspection |
| 1. |
Be sure there is no play in the fuse holders, and that the fuses are held securely. |
| 2. |
Are the fuse capacities for each circuit correct? |
| 3. |
Are there any blown fuses?
If a fuse is to be replaced, be sure to use a new fuse of the
same capacity. Always determine why the fuse blew first and completely
eliminate the problem before installing a new fuse. |
| Removal |
| 1. |
Disconnect the negative(-) battery terminal. |
| 2. |
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad") |
| 3. |
Disconnect the connectors (A) from the IPM (Intelligent intergrated Platform Module).
|
| 4. |
Remove the IPM after loosening the mounting nuts (2EA) and bolt (1EA). |
| 5. |
Disconnect the connectors from the back side of the IPM. |
| Installation |
| 1. |
Install IPM (Intelligent intergrated Platform Module). |
| 2. |
Connect the IPM connector. |
| 3. |
Install the crash pad lower panel. |