Kia Cadenza: Seat Belt Pretensioner / Seat Belt Pretensioner (BPT) Repair procedures

Kia Cadenza YG 2016-2025 Service Manual / Restraint / Seat Belt Pretensioner / Seat Belt Pretensioner (BPT) Repair procedures

Removal
1.
Disconnect the battery negative cable, and wait for at least thirty seconds before beginning work.
2.
The seat belt emergency fastening device (A) be removed after pushing the lock pin (B) as arrow direction.

3.
Remove the door scuff trim.
(Refer to Body - "Door scuff trim")
4.
Remove the center pillar trim
(Refer to Body - "Center pillar trim")
5.
Remove the upper anchor bolt.
6.
Disconnect the seat belt pretensioner connector (C).

7.
Loosen the seat belt pretensioner mounting bolts (A,B) and remove the seat belt pretensioner.
Installation
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least thirty seconds.
3.
Install the seat belt pretensioner with a bolts (A,B).

Tightening torque
Bolt B: 39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)

4.
Connect the seat belt pretensioner (BPT) connector (C).
5.
Install the upper anchor bolts.

Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)

6.
Install the center pillar trim
(Refer to Body - "Center pillar trim")
7.
Install the door scuff trim.
(Refer to Body - "Door scuff trim")
8.
Insert the seat belt to the anchor pretensioner (A).

   
Make sure the lock pin is connected in properly.
9.
Reconnect the battery negative cable.
10.
After installing the seat belt pretensioner, confirm proper system operation:
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
Seat Belt Pretensioner (BPT) Components and Components Location
Components ...

Emergency Fastening Device (EFD) Description and Operation
Description Emergency Fastening Device (EFD) operates as well as Belt Pretensioner at the same time If it gets into its deploy condition after a collision. It is located at near anchor on drive ...

Other information:

Kia Cadenza YG 2016-2025 Service Manual: Engine Control Module (ECM) Schematic Diagrams


ECM Terminal And Input/Output signal ECM Terminal Function Connector [E600-A] Pin No.DescriptionConnected to1- 2- 3- 4Immobilizer Lamp control outputImmobilizer Lamp [Without Button Engine Start System]5Power groundChassis Ground6Power groundChassis Ground7- 8- 92nd CAN [High]Mu ...

Kia Cadenza YG 2016-2025 Service Manual: Starter Description and Operation


Description The starting system includes the battery, starter, solenoid switch, ignition switch, inhibitor switch (A/T), clutch pedal switch (M/T), ignition lock switch, connection wires and the battery cable. When the ignition key is turned to the start position, current flows and energizes ...

Copyright © www.kcadenzavg.com 2017-2025