| Specification |
| Item | Description | ||||
| Power source | 3V | ||||
| Operating temperature | -20°C ~ +60°C (-4°F ~ +140°F) | ||||
| RF Modulation | FSK | ||||
| LF Modulation | ASK | ||||
| RF frequency | 433.92MHz | ||||
| Battery | 1EA (CR2032)
| ||||
| Button number | 3 | ||||
| Function | Door lock | ||||
| Door unlock | |||||
| Trunk lid open |
Component Location 1. Hood switch2. Burglar horn3. IPM and RF antenna4. Key warning switch5. Front door switch6. Front door lock actuator & switch7.
Teaching Procedures 1. Key Teaching Procedure Key teaching must be done after replacing a defective PCM(ECM) or when providing additional keys to the vehicle owner. The procedure starts with an PCM(ECM) request for vehicle specific data (PIN code: 6digits) from the tester.
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad") 3. Disconnect the 5P connector of the SMARTRA unit and then remove the SMARTRA unit (A) after loosening the bolt. Installation 1.