Kia Cadenza: Intake And Exhaust System / Variable Intake Solenoid(VIS) Actuator Repair procedures

Kia Cadenza YG 2016-2024 Service Manual / Engine Mechanical System / Intake And Exhaust System / Variable Intake Solenoid(VIS) Actuator Repair procedures

Removal and Installation
VIS 1 [Intake Manifold]
1.
Disconnect the battery "-" terminal.
2.
Remove the engine cover.
3.
Disconnect the VIS actuator hose (A).
4.
Remove the VIS actuator (B).

Tightening torque :
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

5.
Install in the reverse order of removal.
VIS 2 [Surge Tank]
1.
Disconnect the battery "-" terminal.
2.
Remove the engine cover.
3.
Disconnect the VIS actuator hose (A).
4.
Remove the VIS actuator (B).

Tightening torque :
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

5.
Install in the reverse order of removal.
Exhaust Manifold Repair procedures
Removal and Installation [LH] 1. Disconnect the LH front and rear heated oxygen sensor (HO2S) connector. (Refer to Fuel System - "Heated Oxygen Sensor (HO2S)") 2. Remove the front muffler ...

Muffler Components and Components Location
Components 1. Front muffler2. Catalytic converter & center muffler assembly3. Main muffler4. Gasket5. Hanger ...

Other information:

Kia Cadenza YG 2016-2024 Service Manual: Repair procedures


General Inspection After or before servicing the EPS system, perform the troubleshooting and test procedure as follows. Compare the system condition with normal condition in the table below and if abnormal symptom is detected, perform necessary remedy and inspection. Test conditionNormal ...

Kia Cadenza YG 2016-2024 Service Manual: Schematic Diagrams


System Block Diagram Component Parts And Function Outline Component partFunctionVehicle-speed sensorConverts vehicle speed to pulse.ECMReceives signals from sensor and control switches.Cruise control indicatorIlluminate when CRUISE main switch is ON (Built into cluster)Cruise Control switchesC ...

Copyright © www.kcadenzavg.com 2017-2024