Kia Cadenza YG: Engine Mechanical System / Intake And Exhaust System
- Air Cleaner Components and Components Location
- Air Cleaner Repair procedures
- Surge Tank Components and Components Location
- Surge Tank Repair procedures
- Intake Manifold Components and Components Location
- Intake Manifold Repair procedures
- Exhaust Manifold Components and Components Location
- Exhaust Manifold Repair procedures
- Variable Intake Solenoid(VIS) Actuator Repair procedures
- Muffler Components and Components Location
- Muffler Repair procedures
Removal and Installation 1. Remove the oil level gauge rod (A) and the oil level gauge (B). Tightening torque: 18.6 ~ 22.6N.m (1.9 ~ 2.3kgf.m, 13.
Components 1. Air duct2. Breather hose3. Air intake hose4. Air cleaner assembly
Other information:
Kia Cadenza YG 2016-2021 Service Manual: Compressor Repair procedures
Removal 1. If the compressor is marginally operable, run the engine at idle speed, and let the air conditioning work for a few minutes, then shut the engine off. 2. Disconnect the negative cable from the battery. 3. Recover the refrigerant with a recovery/charging station.
Kia Cadenza YG 2016-2021 Service Manual: Receiver-Drier Repair procedures
Replacement 1. Remove the condenser, and then remove the bottom cap (B) with L wrench (A) from the condenser. Tightening torque : 9.8~14.7N.m (1.0~1.5kgf.m, 7.2~10.8 lb-ft) 2. Remove the desiccant (A) from condenser using a long nose plier.
Categories
- Manuals Home
- Kia Cadenza Owners Manual
- Kia Cadenza Service Manual
- Timing Chain Repair procedures
- Rail Pressure Sensor (RPS) Schematic Diagrams
- Driveshaft and axle
- New on site
- Most important about car
