Kia Cadenza YG: Lubrication System / Oil Level Gauge & Pipe Repair procedures

Removal and Installation
1.
Remove the oil level gauge rod (A) and the oil level gauge (B).

Tightening torque:
18.6 ~ 22.6N.m (1.9 ~ 2.3kgf.m, 13.7 ~ 16.6lb-ft)

   
When installing, apply engine oil to the O-ring and take care the O-ring not to be damaged.
Always use a new O-ring.
2.
Installation is in the reverse order of removal.

    Components 1. Oil level gauge2. Oil level gauge pipe3. O-ring

    Other information:

    Kia Cadenza YG 2016-2021 Service Manual: Height Sensor Repair procedures

    Removal Height Sensor 1. Disconnect the negative (-) battery terminal. 2. Remove the height sensor linkage (A) installed on the front axle and rear axle. [Front] [Rear] Installation Height Sensor 1. Install the height sensor assembly after connecting the connector.

    Kia Cadenza YG 2016-2021 Service Manual: Troubleshooting

    Troubleshooting Problem Symptoms Table Before replacing or repairing air conditioning components, first determine if the malfunction is due to the refrigerant charge, air flow or compressor. Use the table below to help you find the cause of the problem.

    Categories

     
    Copyright © 2026 www.kcadenzavg.com - 0.0449