Kia Cadenza YG: Engine Mechanical System / Intake And Exhaust System
- Air Cleaner Components and Components Location
- Air Cleaner Repair procedures
- Surge Tank Components and Components Location
- Surge Tank Repair procedures
- Intake Manifold Components and Components Location
- Intake Manifold Repair procedures
- Exhaust Manifold Components and Components Location
- Exhaust Manifold Repair procedures
- Variable Intake Solenoid(VIS) Actuator Repair procedures
- Muffler Components and Components Location
- Muffler Repair procedures
Removal and Installation 1. Remove the oil level gauge rod (A) and the oil level gauge (B). Tightening torque: 18.6 ~ 22.6N.m (1.9 ~ 2.3kgf.m, 13.
Components 1. Air duct2. Breather hose3. Air intake hose4. Air cleaner assembly
Other information:
Kia Cadenza YG 2016-2021 Service Manual: Refrigerant line Repair procedures
Replacement 1. Discharge refrigerant from refrigeration system. 2. Replace faulty tube or hose. Cap the open fittings immediately to keep moisture or dirt out of the system. 3. Tighten joint of bolt or nut to specified torque.
Kia Cadenza YG 2016-2021 Service Manual: Intake Actuator Repair procedures
Inspection 1. Ignition "OFF". 2. Disconnect the intake actuator connector. 3. Verify that the actuator operates to the recirculation position when connecting 12V to the terminal 3 and grounding terminal 7. 4. Verify that the intake actuator operates to the fresh position when connecting in the reverse.
Categories
- Manuals Home
- Kia Cadenza Owners Manual
- Kia Cadenza Service Manual
- High Pressure Fuel Pump Repair procedures
- Driveshaft and axle
- Mode Control Actuator Repair procedures
- New on site
- Most important about car
