Kia Cadenza YG: Intake And Exhaust System / Surge Tank Components and Components Location
| Components |
| 1. Surge tank 2. Surge tank stay |
Removal and Installation 1. Remove the battery. (Refer to Engine Electrical System - "Battery") 2. Remove the engine cover. 3. Remove the air duct (A).
Removal and Installation To avoid damage, unplug the wiring connectors carefully while holding the connector portion. Mark all wiring and hoses to avoid misconnection.
Other information:
Kia Cadenza YG 2016-2021 Service Manual: Height Sensor Repair procedures
Removal Height Sensor 1. Disconnect the negative (-) battery terminal. 2. Remove the height sensor linkage (A) installed on the front axle and rear axle. [Front] [Rear] Installation Height Sensor 1. Install the height sensor assembly after connecting the connector.
Kia Cadenza YG 2016-2021 Service Manual: Immobilizer Control Unit Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad") 3. Disconnect the 5P connector of the SMARTRA unit and then remove the SMARTRA unit (A) after loosening the bolt. Installation 1.
Categories
- Manuals Home
- Kia Cadenza Owners Manual
- Kia Cadenza Service Manual
- Timing Chain Repair procedures
- Alternator Schematic Diagrams
- High Pressure Fuel Pump Repair procedures
- New on site
- Most important about car
