Kia Cadenza YG: Driveshaft and axle
- Specifications
- Special Service Tools
- Troubleshooting
- Front Axle Assembly
- Driveshaft Assembly
- Rear Axle Assembly
Removal 1. Remove the center console assembly. (Refer to Body - "Console") 2. Remove the duct (A). 3. Remove the control cable (B). 4.
Specification Engine & T/MJoint typeMax. permissible angleInnerOuterInnerOuterLambda 3.3 GDIVTJ#25BJ#2621°46.5° Tightening Torques ItemN.
Other information:
Kia Cadenza YG 2016-2021 Service Manual: Surround View Monitoring Unit Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the glove box housing. (Refer to Body - "Glove Box Housing") 3. Remove the SVM unit (B) after disconnecting the connectors (A) and mounting bolts. Installation 1. Install the SVM unit.
Kia Cadenza YG 2016-2021 Service Manual: Blind Spot Detection Radar Calibration Description and Operation
Description To sense the cars exactly in the next lane with the radar, the direction of the sensor and the direction of the vehicle have to align. This is BSD unit alignment. If this alignment is not performed as below illustration, the degradation of detection performance and the cause of false alarms.
Categories
- Manuals Home
- Kia Cadenza Owners Manual
- Kia Cadenza Service Manual
- Battery Troubleshooting
- Suspension System
- Schematic Diagrams
- New on site
- Most important about car
