Kia Cadenza YG: Air Conditioning System / A/C Pressure Transducer Description and Operation
Kia Cadenza YG 2016-2021 Service Manual / Heating,Ventilation, Air Conditioning / Air Conditioning System / A/C Pressure Transducer Description and Operation
| Description |
A/C pressure transducer convert the pressure value of high
pressure line into voltage value after measure it. By converted voltage
value, engine ECU controls cooling fan by operating it high speed or low
speed. Engine ECU stop the operation of compressor when the temperature
of refrigerant line is so high or so low irregularly to optimize air
conditioning system.
Component Location
Inspection 1. Measure the pressure of high pressure line by measuring voltage output between NO.1 and NO.2 terminals. 2. Inspect the voltage value whether it is sufficient to be regular value or not.
Other information:
Kia Cadenza YG 2016-2021 Service Manual: Immobilizer Control Unit Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad") 3. Disconnect the 5P connector of the SMARTRA unit and then remove the SMARTRA unit (A) after loosening the bolt. Installation 1.
Kia Cadenza YG 2016-2021 Service Manual: Start/Stop Button Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Using a screw driver or remover, remove the center fascia lower panel (A). 3. Remove the in-car hose (A) and disconnect the connectors (B) from the heater & A/C control unit. 4.
Categories
- Manuals Home
- Kia Cadenza Owners Manual
- Kia Cadenza Service Manual
- Components and Components Location
- Body Electrical System
- Body (Interior and Exterior)
- New on site
- Most important about car
Copyright © 2026 www.kcadenzavg.com - 0.0299