Kia Cadenza YG: Body Electrical System / Adaptive Front Lighting System
- Specifications
- Components and Components Location
- Schematic Diagrams
- Description and Operation
- Repair procedures
- Adaptive Front Lighting System Description and Operation
- Adaptive Front Lighting System Repair procedures
- Height Sensor Repair procedures
Removal Height Sensor 1. Remove the height sensor connector (A). 2. Loosen the mounting bolts(Body: 2EA, chassis: 1EA) from height sensor bracket.
Specifications ContentValueAFLSNominal VoltageDC 13.5VOperating VoltageDC 9~16VOperating Temperature-40°C ~ +85°C
Other information:
Kia Cadenza YG 2016-2021 Service Manual: Repair procedures
Removal 1. Remove the trunk trim in the trunk after removing the screws and clips. (Refer to Body - "Trunk") 2. Remove the camera holder (A) as shown arrow direction, and then remove the back view camera (B). Installation 1. Install the back view camera and camera holder.
Kia Cadenza YG 2016-2021 Service Manual: Blind Spot Detection Radar Calibration Description and Operation
Description To sense the cars exactly in the next lane with the radar, the direction of the sensor and the direction of the vehicle have to align. This is BSD unit alignment. If this alignment is not performed as below illustration, the degradation of detection performance and the cause of false alarms.
Categories
- Manuals Home
- Kia Cadenza Owners Manual
- Kia Cadenza Service Manual
- Timing Chain Repair procedures
- General Information
- Driveshaft and axle
- New on site
- Most important about car
