Kia Cadenza YG: Auto Lighting Control System / Auto Light Switch Repair procedures
Kia Cadenza YG 2016-2021 Service Manual / Body Electrical System / Auto Lighting Control System / Auto Light Switch Repair procedures
| Inspection |
Lighting Switch Inspection
With the multi function switch in each position, make sure
that continuity exists between the terminals below. If continuity is not
as specified, replace the multi-function switch.
Lighting Switch (Auto Light)
Circuit Diagram
Inspection In the state of IGN1 ON, when multi function switch module detects auto light switch on, tail lamp relay output and head lamp low relay output are controlled according to auto light sensor''s input.
Other information:
Kia Cadenza YG 2016-2021 Service Manual: Antenna Coil Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad") 3. Disconnect the 6P connector (B) of the coil antenna and then remove the coil antenna (A) after loosening the screw.
Kia Cadenza YG 2016-2021 Service Manual: Components and Components Location
C
Categories
- Manuals Home
- Kia Cadenza Owners Manual
- Kia Cadenza Service Manual
- Engine Control / Fuel System
- Timing Chain Repair procedures
- Emission Control System
- New on site
- Most important about car
Copyright © 2026 www.kcadenzavg.com - 0.0221