Kia Cadenza YG: Engine Control System / CVVT Oil Temperature Sensor (OTS) Repair procedures

Kia Cadenza YG 2016-2021 Service Manual / Engine Control / Fuel System / Engine Control System / CVVT Oil Temperature Sensor (OTS) Repair procedures

Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the OTS connector.
3.
Remove the OTS. (Refer to "Removal")
4.
After immersing the thermistor of the sensor into engine coolant, measure resistance between the OTS terminals 1 and 2.
5.
Check that the resistance is within the specification.
Specification: Refer to “Specification”
Removal
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Remove the air cleaner assembly.
(Refer to Engine Mechanical System - "Air Cleaner")
3.
Disconnect the connector (A), and then remove the CVVT oil temperature sensor (B).

Installation
   
•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
   
•
Apply the sealant (LOCTITE FED546 or equivalent) to the sensor.
   
•
Insert the sensor in the installation hole and be careful not to damage when installation.
1.
Install in the reverse order of removal.
CVVT oil temperature sensor installation:
34.3 ~ 41.1 N.m (3.5 ~ 4.5 kgf.m, 25.3 ~ 32.5 lb-ft)

    Circuit Diagram

    Description Accelerator Position Sensor (APS) is installed on the accelerator pedal module and detects the rotation angle of the accelerator pedal.

    Other information:

    Kia Cadenza YG 2016-2021 Service Manual: Adaptive Front Lighting System Repair procedures

    Removal 1. Disconnect the negative (-) battery terminal. 2. Using a screwdriver or remover, remove the crash pad side cover (A). [RH] 3. Disconnect the stopper (B) from the glove box (A). 4. Disconnect the air damper (A) from the glove box (B).

    Kia Cadenza YG 2016-2021 Service Manual: Blower Resistor Repair procedures

    Inspection 1. Measure terminal - to - terminal resistance of blower resistor. 2. If measure resistance isnot within specification, the blower resistor must be replaced. Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower cover (A) and then disconnect the connector (B).

    Categories

     
    Copyright © 2026 www.kcadenzavg.com - 0.0294