Kia Cadenza: Engine Control System / ETC (Electronic Throttle Control) System Troubleshooting

Kia Cadenza YG 2016-2025 Service Manual / Engine Control / Fuel System / Engine Control System / ETC (Electronic Throttle Control) System Troubleshooting

Fail-Safe Mode

Item	Fail-Safe
ETC Motor	Throttle valve stuck at 7°
TPS	TPS 1 fault	ECM looks at TPS2
	TPS 2 fault	ECM looks at TPS1
	TPS 1,2 fault	Throttle valve stuck at 7°
APS	APS 1 fault	ECM looks at APS 2
	APS 2 fault	ECM looks at APS 1
	APS 1,2 fault	Engine idle state

When throttle value is stuck at 7°, engine speed is limited at below 1,500rpm and vehicle speed at maximum 40 ~ 50 km/h (25 ~ 31 mph)

ETC (Electronic Throttle Control) System Description and Operation

Description The Electronic Throttle Control (ETC) System consists of a throttle body with an integrated control motor and throttle position sensor (TPS). Instead of the traditional throttle cab ...

ETC (Electronic Throttle Control) System Specifications

Specification [Throttle Position Sensor (TPS)] Throttle angle(°)Output Voltage (V) [Ref=5V]TPS1TPS200.54.5100.964.05201.413.59301.873.14402.322.68502.782.23603.231.77703.691.32804.140.86904.60. ...

Other information:

Kia Cadenza YG 2016-2025 Service Manual: Repair procedures

General Inspection After or before servicing the EPS system, perform the troubleshooting and test procedure as follows. Compare the system condition with normal condition in the table below and if abnormal symptom is detected, perform necessary remedy and inspection. Test conditionNormal ...

Kia Cadenza YG 2016-2025 Service Manual: Knock Sensor (KS) Repair procedures

Removal [Knock Sensor #1 (Bank 1)] 1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disconnect the knock sensor connector (A). 3. Remove the intake manifold. (Refer to Engine Mechanical System - "Intake Manifold") 4. Remove the installation bolt ...