Other information:
Inspection
1.
Turn ignition switch OFF.
2.
Remove the battery and battery tray.
(Refer to Engine Electrical System - "Battery")
3.
Disconnect the solenoid valve connector (A).
4.
Measure the resistance between power terminal (5) and signal terminal (12).
Specification : 10.0 ~ ...
Inspection
Tolerance Calibration
Tolerance calibration compensates for the error margins of
surround view video that occur due to the installation tolerance when
the four cameras that comprise the SVM system are installed.
You must carry out tolerance calibration if you do any of the follo ...