Kia Cadenza YG: Engine Control System / Fuel Tank Pressure Sensor (FTPS) Specifications
| Specification |
| Pressure [kPa (kgf/cm², psi)] | Output Voltage (V) |
| -6.67 (-0.06, -0.97) | 0.5 |
| 0 | 2.5 |
| +6.67 (0.068, 0.97) | 4.5 |
Description Fuel Tank Pressure Sensor (FTPS) is a component of the evaporative emission control system and is installed on the fuel tank, the fuel pump, or the canister.
Circuit Diagram
Other information:
Kia Cadenza YG 2016-2021 Service Manual: Immobilizer Control Unit Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad") 3. Disconnect the 5P connector of the SMARTRA unit and then remove the SMARTRA unit (A) after loosening the bolt. Installation 1.
Kia Cadenza YG 2016-2021 Service Manual: Blower Unit Repair procedures
Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the heater and blower unit.(Refer to HA group – heater unit). 3. Remove the blower unit (A) from the heater unit after loosening a mounting bolt and 3 screws. Make sure that there is no air leaking out of the blower and duct joints.
Categories
- Manuals Home
- Kia Cadenza Owners Manual
- Kia Cadenza Service Manual
- Engine Control / Fuel System
- Body Electrical System
- Crankshaft Damper Pulley Components and Components Location
- New on site
- Most important about car
