Kia Cadenza YG: Engine Control System / Barometric Pressure Sensor (BPS) Repair procedures

Kia Cadenza YG 2016-2021 Service Manual / Engine Control / Fuel System / Engine Control System / Barometric Pressure Sensor (BPS) Repair procedures

Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the BPS at idle and IG ON.
Specification: Refer to "Specification"
Removal
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Disconnect the barometric pressure sensor connector (A).
3.
Remove the installation bolt (B), and then remove the sensor from the air cleaner assembly.

Installation
   
•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
   
•
Insert the sensor in the installation hole and be careful not to damage when installation.
1.
Install in the reverse order of removal.
Barometric pressure sensor installation bolt:
3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)

    Circuit Diagram

    Description Intake Air Temperature Sensor (IATS) is included inside Barometric Pressure Sensor (BPS) and detects the intake air temperature. To calculate precise air quantity, correction of the air temperature is needed because air density varies according to the temperature.

    Other information:

    Kia Cadenza YG 2016-2021 Service Manual: Components and Components Location

    C

    Kia Cadenza YG 2016-2021 Service Manual: Auto defoging actuator Repair procedures

    Inspection 1. Ignition "OFF”. 2. Disconnect the connector of auto defog control actuator. 3. Verify that the auto defog control actuator operates to the defrost ON mode when connecting 12V to the terminal 3 and grounding terminal 7. 4.

    Categories

     
    Copyright © 2026 www.kcadenzavg.com - 0.0288