Kia Cadenza: Engine Control System / Fuel Pressure Control Valve (FPCV) Repair procedures
1. |
Turn the ignition switch OFF and disconnect the battery negative (-) cable. |
2. |
Disconnect the fuel pressure regulator valve connector. |
3. |
Measure resistance between the fuel pressure regulator valve terminals 1 and 2. |
4. |
Check that the resistance is within the specification.
Specification: Refer to “Specification”
|
|
(Refer to Fuel Delivery System - "High Pressure Fuel Pump")
(Refer to Fuel Delivery System - "High Pressure Fuel Pump")
Description
Canister Close Valve (CCV) is installed on the canister
ventilation line. It seals evaporative emission control system by
shutting the canister from the atmosphere when leakage dete ...
Other information:
EPB Circuit Diagram
EPB connector input/output
Pin No.Description1CAN_High2CAN_Low18IGN (+)19EPB Switch Signal 121EPB Switch Signal 327EPB Switch Signal 229EPB Switch Signal 433Rear Left Motor (-)34Ground35Ground36Rear Right Motor (-)37Rear Right Motor (+)38Rear Left Motor (+)39Battery (Rear R ...
Removal
1.
Remove the air duct (A).
2.
Disconnect the battery (-) terminal (A)and then (+) terminal (B).
3.
Remove the battery mounting bracket (D) and the insulation pad (C), and then remove the battery (E).
4.
Disconnect the front connector mounting clip (A).
5.
Remove the batt ...