Kia Cadenza YG: Engine Control System / Manifold Absolute Pressure Sensor (MAPS) Specifications
| Specification |
| Pressure [kPa (kgf/cm², psi)] | Output Voltage (V) |
| 20.0 (0.20, 2.90) | 0.79 |
| 46.66 (0.47, 6.77) | 1.84 |
| 101.32 (1.03, 14.7) | 4.0 |
Description Manifold Absolute Pressure Sensor (MAPS) is a speed-density type sensor and is installed on the surge tank. It senses absolute pressure of the surge tank and transfers the analog signal proportional to the pressure to the ECM.
Circuit Diagram
Other information:
Kia Cadenza YG 2016-2021 Service Manual: Immobilizer Control Unit Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad") 3. Disconnect the 5P connector of the SMARTRA unit and then remove the SMARTRA unit (A) after loosening the bolt. Installation 1.
Kia Cadenza YG 2016-2021 Service Manual: Compressor Repair procedures
Removal 1. If the compressor is marginally operable, run the engine at idle speed, and let the air conditioning work for a few minutes, then shut the engine off. 2. Disconnect the negative cable from the battery. 3. Recover the refrigerant with a recovery/charging station.
Categories
- Manuals Home
- Kia Cadenza Owners Manual
- Kia Cadenza Service Manual
- Body Electrical System
- Body (Interior and Exterior)
- Crankshaft Damper Pulley Components and Components Location
- New on site
- Most important about car
