| Troubleshooting |
| Symptom | Suspect Area | Remedy (Refer to page) |
| Water leaks from panoramaroof | Deteriorated roof lid weatherstrip | Replace |
| Excessive roof lid-to-body clearance and improperly fitted weatherstrip | Adjust | |
| Wind noise around panoramaroof | Loose or deformed deflector, gaps in body work | Retighten adjust or replace |
| Noise heard when opening. closing panoramaroof | Foreign particles lodged in guide rail | Check drive cable and guide rails for foreign particles |
| Loose guide rails and lid | Retighten | |
| Motor runs but panoramaroof does not move or moves only partially | Foreign particles lodged in guide rail | Adjust or replace |
| Incorrect engagement of motor pinion with drive cable | ||
| Decrease in motor`s clutch slipping force | ||
| Increased
panoramaroof sliding resistanceor interference of sunroof with drive
cables, weatherstrip, etc. due tomal adjustment of sunroof | ||
| Noise in motor (clutch slipping noise from motor when sunroofIs fully opened or closed is not an unusual noise | Incorrect engagement of motor pinion with drive cable | Check pinion installation and retighten motor |
| Worn out or damaged motor pinion bearing | Replace motor assembly | |
| Worn out or deformed drive cable | Replace | |
| Door glass fails to operate up and down | Incorrect window glass installation | Adjust position |
| Damaged or faulty regulator arm or regulator | Correct or replace | |
| Door does not open or close completely | Incorrect door installation | Adjust position |
| Defective door check assembly | Correct or replace | |
| Door hinge requires grease | Apply grease | |
| Hood does not open or close completely | Striker and latch not properly aligned | Adjust |
| Incorrectly installed hood | Adjust | |
| Incorrect hood bumper height | Adjust | |
| Water leak through windshield end rear window | Defective seal | Fill with sealant |
| Defective flange | Correct |
Special Service Tools Tool (Number and name)IllustrationUse09861-31100Sealant cut-out toolCutting windshield sealant(use with 09861-31200)09861-31200Sealant cutting bladeCutting windshield sealant(use with 09861-31100)09861-31000Windshield moulding removerWindshield moulding removal09880-4F000Hog ring clip installerHog ring clip installation09816-2P100Power silent cutting toolTool box for removing panorama sunroof09816-2P110Air power toolAir tool for installing blade09816-2P121Cutter-1Blade for removing the front and side area of panorama sunroof (This blade has a inclination to push upward.
Troubleshooting Examples of False-Alarm Occurrence from system characteristics (It’s not a problem) – Characteristics of EM Wave : EM Waves are reflected against all material and especially metal very well. Reflections of EM Waves are varies with the shape of object.
Replacement 1. Discharge refrigerant from refrigeration system. 2. Replace faulty tube or hose. Cap the open fittings immediately to keep moisture or dirt out of the system. 3. Tighten joint of bolt or nut to specified torque.