| Removal |
| 1. |
Remove the fuel pump.
(Refer to Fuel Delivery System - “Fuel Pump”) |
| 2. |
Disconnect the electric pump wiring connector (A) and the fuel sender connector (B).
|
| 3. |
Remove the cushion pipe fixing clip (A), and then separate the head assembly (B) from reservoir cup.
|
| 4. |
Remove the return nozzle (B) after releasing the fixing hook (A).
|
| 5. |
Remove the reservoir-cup after releasing the fixing hooks (A).
|
| 6. |
Remove the pre-filter (B) after releasing the fixing hooks (A).
|
| 7. |
Separate the electric pump motor (A) and regulator (B) from the fuel filter (C).
|
| Installation |
| 1. |
Install in the reverse order of removal. |
Inspection [Fuel pump] 1. Turn the ignition switch OFF, and then remove battery (-) cable. 2. Remove the fuel pump assembly. 3. Check that motor operates properly when applying battery voltage to terminals 2 and 4 of fuel pump connector (A).
Removal 1. Remove the fuel pump. (Refer to Fuel Delivery System - “Fuel Pump”) 2. Disconnect the electric pump wiring connector (A) and the fuel sender connector (B).
Removal 1. Disconnect the negative (-) battery terminal. 2. Using a screwdriver or remover, remove the crash pad side cover (A). [RH] 3. Disconnect the stopper (B) from the glove box (A). 4. Disconnect the air damper (A) from the glove box (B).
Inspection Tolerance Calibration Tolerance calibration compensates for the error margins of surround view video that occur due to the installation tolerance when the four cameras that comprise the SVM system are installed. You must carry out tolerance calibration if you do any of the following.