Kia Cadenza YG: Automatic Transaxle Control System / Input Speed Sensor Specifications
| Specifications |
| Operation condition [°C(°F)] | ((-)40~150)) -40~302 | |
| Air gap(mm)in. | (0.95~1.65)0.037~0.065 | |
| Output voltage(V) | High | 1.18~1.68 |
| Low | 0.59~0.84 | |
Description Input speed sensor is a vital unit that measures the rate of rotation of the input shaft inside the transaxle and delivers the readings to the Transaxle Control Module(TCM).
Circuit Diagram
Other information:
Kia Cadenza YG 2016-2021 Service Manual: Compressor Repair procedures
Removal 1. If the compressor is marginally operable, run the engine at idle speed, and let the air conditioning work for a few minutes, then shut the engine off. 2. Disconnect the negative cable from the battery. 3. Recover the refrigerant with a recovery/charging station.
Kia Cadenza YG 2016-2021 Service Manual: Mode Control Actuator Repair procedures
Inspection 1. Ignition "OFF” 2. Disconnect the connector of mode control actuator. 3. Verify that the mode control actuator operates to the defrost mode when connecting 12V to the terminal 3and grounding terminal 7. 4. Verify that the mode control actuator operates to the vent mode when connecting in the reverse.
Categories
- Manuals Home
- Kia Cadenza Owners Manual
- Kia Cadenza Service Manual
- Driveshaft and axle
- Steering System
- Specifications
- New on site
- Most important about car
