Kia Cadenza YG: Automatic Transaxle Control System / 26 Brake Control Solenoid Valve(26/B_VFS) Components and Components Location
Kia Cadenza YG 2016-2021 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / 26 Brake Control Solenoid Valve(26/B_VFS) Components and Components Location
| Component Location |
1. 26 Brake control solenoid valve (26/B_VFS)
Specification Item SpecificationControl typeN/L (Normal Low)Control pressure kpa(kgf/cm², psi)"9.81 ~ 500.14(0.1 ~ 5.1, 1.42 ~ 72.54)"Current value (mA)50 ~ 850Coil resistance(Ω)5.
Description • 26 Brake control solenoid valve is a Variable Force Solenoid (VFS) type. • When TCM supplies variable current to solenoid valve, hydraulic pressure of 26 brake is controlled by solenoid valve.
Other information:
Kia Cadenza YG 2016-2021 Service Manual: Components and Components Location
C
Kia Cadenza YG 2016-2021 Service Manual: Immobilizer Control Unit Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad") 3. Disconnect the 5P connector of the SMARTRA unit and then remove the SMARTRA unit (A) after loosening the bolt. Installation 1.
Categories
- Manuals Home
- Kia Cadenza Owners Manual
- Kia Cadenza Service Manual
- Front Hub - Axle Repair procedures
- Transaxle Control Module (TCM) Repair procedures
- Mode Control Actuator Repair procedures
- New on site
- Most important about car
Copyright © 2026 www.kcadenzavg.com - 0.0238